![hitachi hta-3000 specs hitachi hta-3000 specs](https://s3.manualzz.com/store/data/053853871_1-b2cc8c532f2f516f83858d066134a0ce.png)
If the paint has not peeled off, you need to prepare the surface with a 180 grit sand paper. You can paint your heater and make it look brand new. The paint is tested to resist peak temperatures (non-continuous) of up to 1,200 ☏. It is okay to reach temperatures between 500 ☏ and 900 ☏ upon the start-up of the heater. Make sure you use a chimney thermometer and keep flue temperatures within the comfort zone of 250 ☏ to 475 ☏ when the heater is operated in the slow combustion mode. It is important to identify why the heater has overheated.
![hitachi hta-3000 specs hitachi hta-3000 specs](https://www.radiomuseum.org/images/radio/hitachi_ltd_tokyo/am_fm_stereo_tuner_amplifier_hta_2622889.jpg)
Before setting up your unit, refer to the installation manual.Īs a result of the high temperatures reached ** Some appliances have been tested with a low ceiling. * The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner's manual, catalogues, flyers, magazines and/or web sites). 1 inch = 25.4 mm)Ĭlearance – top (measured from the platform on which the appliance is installed)** Tested and listed as per applicable standards Stainless-steel secondary-air system improving gas combustion
![hitachi hta-3000 specs hitachi hta-3000 specs](https://file.remont-aud.net/archive/_ld/492/26355257.jpg)
Glass surface – dimensions (Width X Height)įirebox lined with refractory bricks for better heat distribution ( 9) The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the wood logs into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion. ( 8) Optimum overall efficiency at a specific burn rate (LHV). ( 7) Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%. ( 4) As measured per CSA B415.1-10 stack loss method. The moisture content is between 19% and 25%. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. Other performances are based on a fuel load prescribed by the standard without any reloading between start and finish. ( 3) The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³ and reloading intervals ranging from 60 to 120 minutes. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure. ( ) Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. ( 2) Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time and maximum heat output. ( 1) This appliance is officially tested and certified by an independent agency.